Elevator Bucket aggregates reasons and treatment methods

Elevator Bucket aggregates reasons and treatment methods
Elevator Bucket conveyor works is to scoop material from the following storage Hopper, conveyor belt or chain lifting to the top, flip down after bypassing the crown chakra, elevator bucket the material into the receiver. If too many base materials in the production process, digging resistance is too large, it will cause a belt slipping or stop motion, occur for several reasons:
Injection flow is too large, hoist items cannot be returned all the flow into the discharge tube and base, caused by such a material increase in the base plug, the solution is to reduce reflux. Injection flow is too large, hoist items cannot be returned all the flow into the discharge tube and base, caused by such a material increase in the base plug, the solution is to reduce reflux.
Feeding is not uniform, sometimes more and sometimes less. When feeding for a long time, feeding amount greater than upgrading, base materials remaining in the accumulation of rising base material, hopper running resistance gradually increased, up to a certain extent, belt slipping occurs, can also cause downtime or motor burnt out. Must be strict control feeding amount, when unloaded driving, gradually open the feed gate. By the frame of the positive holes (Windows hole) observation of material increased. Material surface rough when the axis of the wheel (when material from the angle of 40 degrees), feed gate no longer increases
Sudden outage due to a power failure or other failure, and improve the quality of branches and branch, reversed the hoist, material in the hopper into the frame, frame plug-prone when open. You can install return valve on the side of the elevator shaft, prevent the elevator back.
Large foreign bodies entering the frame causing jams. Installed at the elevator bucket inlet grille mesh, to prevent accidents from happening.
Belt slips, reducing the quantity of hoist lifting, clogging the increased formation of material within the frame. You can increase the tension, preventing belt slippage.

Please refer to the :http://www.mill-industry.net

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: